Moisture
Exotek moisture meters for wood and building materials
The Exotek Instruments series is a new generation of microprocessor controlled, pocket size handheld moisture meters. For quick and accurate non-destructive determination of the moisture content in wood and building materials as well as locating wet areas in floors, roofs and walls made of homogeneous material.
Portable
MC-160SA pin-free moisture meter - RH functionality
The meter works on the principle of measuring the dielectric constant of the material. The field penetration depth is approximately 50 mm. It can be used under outdoor and indoor conditions.
Choice of material code makes measurements more accurate. There are 6 selectable material codes for wood and 5 groups for building materials.
When making Bore hole Test's where the Air Humidity, Relative Humidity (RH) is a more appropriate term. For this reason, the MC-160SA is programmed to calculate the RH value from the moisture content value (only for building material).
MC-380XCA Dual Scanning Depth pin-free moisture meter - RH functionality
The New MC-380XCA is a microprocessor controlled hand-held moisture meter. It is reliable and simple to use and intended for rapid and non-destructive evaluation of the moisture content of wood and building materials, The MC-380XCA can be used in production, inspection control and detection of water damages. In many cases, Relative Humidity (RH) is a more appropriate term. For this reason, the MC-380CXA is programmed to calculate the RH value from the moisture content value for building material. It also has two selectable scanning depths: 10 mm and 100 mm.
MC-460 - Wood Moisture Meter
The MC-460 is a digital hand-held moisture meter for quick and accurate determination of the moisture content in softwood, hardwood, other wood materials according to the resistance measuring procedure.
Over 264 types of wood are registered in 6 measuring groups. Easy and clear operation, good reading off of indicated values, low power consumption, high, long-time stability without readjustment. NEW! Polarization function for fast and accurate reading when moisture content are higher than 15%.
Probes and Equipment
- S-10 Double needle probe-wood
- S-10P Probe, 23 cm for paper and Palm Oil tree fibers
- S-30 Sliding hammer probe
- S-40 Compression Chamber Sampel Cup with
- Connection cable 1,0 m
- Surface electrodes, veneer measuring
- Durable plastic carrying case
- Steel nail for S-10/S-30 probe - Length and measuring depth: 12, 19, 26, 56 mm
- Needle electrodes with Teflon isolation for S-10/S-30 probe - Length and measuring depth: 30, 45 mm